View Full Version : Hi from NJ
I am Aiming for a 777 I recently added GoFlight. not shown is my ch yoke on a 2x4.
using hacked up 777 MelJet panel for autopilot, standby instruments, lights, FreeFD EADI, EICAS, VAS-FMC (was trying to use P8R FMC) and of course widefs.
Geremy Britton
10-23-2007, 03:59 PM
A very good start! Got all the software - so just keep going and it will all pay off. :)
Happy simming, Geremy
Tomlin
10-23-2007, 04:09 PM
... FreeFD EADI, EICAS, VAS-FMC (was trying to use P8R FMC) and of course widefs.
Hi
What did you mean by was trying to use P8R FMC? Have you had issues with it? I would love to try this software to see if it will cause routes to display on the PMRJ ND screen.
Anyone know if this is possible?
737NUT
10-23-2007, 05:01 PM
Nice start! Are going to build an enclosure or will it be open?
Trevor Hale
10-23-2007, 06:04 PM
Great Job,
Please feel free to post the pictures in the gallery.
Best regards,
Trev
Hi
What did you mean by was trying to use P8R FMC? Have you had issues with it? I would love to try this software to see if it will cause routes to display on the PMRJ ND screen.
Anyone know if this is possible?
I entered a route and had taken off but the ap would not start following it. Maybe I will try again someday now that I have VASFMC working. I could put dual FMS in my flight plan. :p
At this point in time, not going to enclose it. The space is somewhat tight unless I take over the other half of the basement.
Tomlin
10-24-2007, 09:05 AM
Thanks for your help, and best of luck on your project!