CPflight MIP & FDS AN1

[indyana1]

Hi,

Just wondering if anyone here is using CPflight's MIP 737 board and FDS AN1 Annunciators?

I've followed all the instructions regarding wiring but when tested through CPflight's test software it is very sporadic. I seem to get the red LED's working but I can't get the Green or Amber LED's to work as they should.

I have tested all the LED's and they are all working OK.

CPflight thinks it might be FDS PCB for the LED's, I just don't know.

If anyone has any suggestions or has a similar setup that can help that would be very much appreciated.

Regards,

Mick CC

[Melnato]

Mate,

Check that you haven't soldered the amber/green LED's upside down...I did two like that;).

The PCB is just an easy means to connect wiring loom to the LED's...that's all...not much can go wrong.

Nat

[indyana1]

Thanks for the help Nat, these were all pre-made by FDS so should all be correct you would think.

Regards,

Mick