PDA

View Full Version : PFD+ND initial problems.


Carlos_Custodio
12-03-2008, 05:00 PM
Hi all
I have two (simple, or maybe stupid) quetsions.
Iīm new on PM and like to know how I make two things.

1) How to start the PFD (GC _PMagenta) with the F4 (pfd+nd) screen.
Every time I start the PFD itīs start with the F1 screen (only pdf).

2) How I move or disable the three bottons (Next, exit, normal graphics)
on the top of the screen.
Iīm using the upper side of my LCD monitor and the bottons are placed
on the graphics (PFD).

Thanks in advance (and sorry for my poor english)
Carlos_Custodio
arwinpoon
12-04-2008, 07:53 AM
Hey Carlos,

I believe you are using the demo version?

1) You cant set the page setting using the demo. It will always go to that page by default, because you are using the demo

2) The 3 buttons, is also related to the demo , the registered version do not have this.
Carlos_Custodio
12-04-2008, 11:37 AM
Hey Carlos,

I believe you are using the demo version?

1) You cant set the page setting using the demo. It will always go to that page by default, because you are using the demo

2) The 3 buttons, is also related to the demo , the registered version do not have this.

Hi

My PM is a old version of a friend that upgrade PM for a new version.

Itīs a old one but when selected to the correct screen run perfectly.

But, if itīs a demo, I can buy a new one..... or use one like FreeFD. Itīs only for flying on my free time. PM is excelent but so expensive only for it.

Thanks a lot,
Carlos.
PaulEMB
12-04-2008, 04:56 PM
Carlos,

If you are using a version given to you by a friend, you probably dont have the licence required to make it run in other than demo mode - to do that check the PM site www.projectmagenta.com for pricing and licencing info.
Carlos_Custodio
12-04-2008, 07:10 PM
Carlos,

If you are using a version given to you by a friend, you probably dont have the licence required to make it run in other than demo mode - to do that check the PM site www.projectmagenta.com (http://www.projectmagenta.com) for pricing and licencing info.

Hi, Paul

Thanks, I wil search this info on the PM site.

Regards,
Carlos.