ian@737ng.co.uk
02-12-2009, 12:47 PM
g'day chaps.......
i've just downloaded the latest version of FS2Phidgets with a view to 'upgrading' some of my outputs using a LED64 board.
first i've got v4.3.8, using fs9.1, fsuipc v3.8.5 and the PMDG737.
i'm using the LED64 'emulator' at the moment before i part with my bucks because i want to see if it is going to do what i want
i've managed to get several 'important' outputs configured and working and i'm delighted.
but i have come across a 'stumbling block' with the Gen1 and 2 Bus Volts assignments.
i can assign them no problem. FS2Phidgets sees the values correctly as 0 when off and 28 when on, but when i try to configure the output (to set the value range where the LED is turned on), i keep getting an error message which reads
Runtime Error '380':
Invalid Property Value
any suggestions, ideas, pointers or instructions gratefully recieved.
thanks for your time and have a great day tomorrow
regards from the welsh borders .... ian
i've just downloaded the latest version of FS2Phidgets with a view to 'upgrading' some of my outputs using a LED64 board.
first i've got v4.3.8, using fs9.1, fsuipc v3.8.5 and the PMDG737.
i'm using the LED64 'emulator' at the moment before i part with my bucks because i want to see if it is going to do what i want
i've managed to get several 'important' outputs configured and working and i'm delighted.
but i have come across a 'stumbling block' with the Gen1 and 2 Bus Volts assignments.
i can assign them no problem. FS2Phidgets sees the values correctly as 0 when off and 28 when on, but when i try to configure the output (to set the value range where the LED is turned on), i keep getting an error message which reads
Runtime Error '380':
Invalid Property Value
any suggestions, ideas, pointers or instructions gratefully recieved.
thanks for your time and have a great day tomorrow
regards from the welsh borders .... ian