barkay
05-25-2009, 01:51 AM
Dear Fellow builders,
I have a servo card which I control the gauges. However very interestingly at the beginning of flight even though everything seems to work perfect if there is no command going to the servo card for a while SIOC seems to forget it. I have only the flaps gauge connected right now therefore the card is not working for anything else.
Does anyone have any idea why this happens?
Thak you and best regards,
barkay
I have a servo card which I control the gauges. However very interestingly at the beginning of flight even though everything seems to work perfect if there is no command going to the servo card for a while SIOC seems to forget it. I have only the flaps gauge connected right now therefore the card is not working for anything else.
Does anyone have any idea why this happens?
Thak you and best regards,
barkay