PM N1 Set and SPD Ref Functions.

[Joe Lavery]

Hi All,

Does anyone know if the N1 Set and SPD Ref rotaries on the AutoBrake panel are supported by PM?

I've found 2 offsets that seem appropriate:

5508 737 Speed Ref
550A 737 N1 Ref Select

However, like many other offsets they don't seem to do anything. I presume some coding in the logic files is needed!

Any help would be appreciated.

Regards

Joe Lavery

[Trevor Hale]

May I suggest you send a PM to Thomas Richter through our site. Like I had mentioned before, Those offsets are reserved but nothing in PM sets them, or unsets them, however If I am not mistaken Thomas Richter's software TSR does this.

Trev

[Joe Lavery]

Thanks again Trev,

I've done as you suggested, I'll see what Thomas has to say.

Regards

Joe.