View Full Version : 737 Trim
Hi
My default fsx 737 trim is way over to the right and nothing seems to centre it. Any suggestions would be appreciated
Mac
Trevor Hale
06-15-2009, 01:34 PM
Just checking, but did you try Numberpad 5?
That was quick off the mark Trev. I'll try that. Many thanks
Trevor Hale
06-15-2009, 02:14 PM
No Problem. I can't remember if NumLock needs to be on of off. But if your views change when you press the numpad 5, then change the state of your NumLock key. LOL
Num 5 centres it for about 20 secs and then it flips back...............
Melnato
06-15-2009, 07:13 PM
Num 5 centres it for about 20 secs and then it flips back.............
I bet you have a UNWANTED joystick button commanding the trim....check through all your controller buttons in FSX
Nat
Thanks for that......disconnecting my yoke solves the problem. Of course I will need the yoke however.........I have a nose down/up trim switch and that shows the + and - changes in the EICAS but does nothing to sort the problem. Do I need to configure the trim switch and if so how?
Regards
Mac