KLM077
10-17-2009, 03:01 AM
Dear Pit builders colleagues,
I've a strange issue with my trim. If i trim to the most outher value the trim starts to go up and down like a switch contiuously switching...
If i trim back to neutral position the effect disappears. This happened to me often when after take of during climbing out.
The following trim hardware : GoFlight LGT (Rotary Encoder brought to pedestal trim wheel).
Software : FsXpand, FreedFD, PM, FS9.
The trim is assigned to the switch on the yoke (Saitek) and to the trimwheel.
Did somebody experianced a similar problem?
How did you solved this?
Looking forward to some advise.
Thanks in advance,
Regards from Bas
KLM077
I've a strange issue with my trim. If i trim to the most outher value the trim starts to go up and down like a switch contiuously switching...
If i trim back to neutral position the effect disappears. This happened to me often when after take of during climbing out.
The following trim hardware : GoFlight LGT (Rotary Encoder brought to pedestal trim wheel).
Software : FsXpand, FreedFD, PM, FS9.
The trim is assigned to the switch on the yoke (Saitek) and to the trimwheel.
Did somebody experianced a similar problem?
How did you solved this?
Looking forward to some advise.
Thanks in advance,
Regards from Bas
KLM077