dimimiras
11-11-2009, 09:16 AM
dear friends
i am about to start the second faze of my sim and pwork with a small overhead replica of 737 .
I have about 50 tongle switches to wire and i need an advise to use BU0836X which i already used to wire my autopilot but with the small problem that the encoders are not precise and they loose few hits or to go to a new controler U-HID PCB which looks very promissing .I am not very good with electronics so i need simple ways to make it work.I ma going to use only tongle switches .
Any advise???????
i am about to start the second faze of my sim and pwork with a small overhead replica of 737 .
I have about 50 tongle switches to wire and i need an advise to use BU0836X which i already used to wire my autopilot but with the small problem that the encoders are not precise and they loose few hits or to go to a new controler U-HID PCB which looks very promissing .I am not very good with electronics so i need simple ways to make it work.I ma going to use only tongle switches .
Any advise???????