Mirage
11-13-2009, 10:33 AM
3DOF – hydraulic ready! Electronic ready! need just some connection advice!
I need understand principle of “feedback” & “close loop” connection, if I want motion base move both option: manual & automatic, how correct make connection for correct way closing loop?
- If motion base works automatic mode, loop closing from proportional valve driver (from cylinder position sensor to ->coil PWM modulator) correct?
- But how “close loop” if base motion under manual control? (E.g. MFS …NFS...etc) need write some option from software driver? Or?
I need understand principle of “feedback” & “close loop” connection, if I want motion base move both option: manual & automatic, how correct make connection for correct way closing loop?
- If motion base works automatic mode, loop closing from proportional valve driver (from cylinder position sensor to ->coil PWM modulator) correct?
- But how “close loop” if base motion under manual control? (E.g. MFS …NFS...etc) need write some option from software driver? Or?