View Full Version : PM systems and FS2phidgets on the same time?
Olympic260
12-17-2009, 06:22 AM
Is it possible to run PMSystems, with the phidgets enabled and fs2phidgets on the same time without problems?
If yes how?? If I have fs2phid operational then at pmsystems loads only one led64 and nothing happens
If pmsystems is on and i load fs2ph then no cards are found on fs2phidg.
BR
CocnutAir
12-18-2009, 02:57 PM
Something I have not tried.
CocnutAir
12-19-2009, 10:42 AM
I had a look at the Phidgets web site and noted the following:
"The Phidget Web Service is a socket based server which allow Phidgets to be opened remotely, over a network. The Web Service also serves as an interface for Phidgets to be used in Adobe Flash and Flex with Actionscript 3.0 and allows a single Phidget to be opened by multiple applications - something that cannot be done with the regular interface".
FS2Phidgets uses the regular interface. Not sure about pmSystems.
Does raise the question: Does one want two applications controlling the same servo motor, or two applications both responding to the same switch? How does one specify which application controls which device?