Using 12 position switch as rotary encoder on BU0836X

[Masterploxis]

Hello all,

i need help with preparing a 12 position switch for use as a rotary encoder. I removed the stoper from the inside and shortened the spring a bit.

I already read the PDF file from Ian (737ng.co.uk) - but the switch he used is different. (2 commons with 6 pins each).

I have 12 pins on the outer ring, numbered 1 to 12, and 3 pins on the inner ring labeled as A,B,C.

So can anybody give me input how to manipulate this switch, that i can connect it to a bu0836x to get it working as rotary encoder (+ signal clockwise, - signal counterclockwise) ?

Any help is highly appreciated.

Regards from Germany

Andreas

[Buddym]

I have not tried it, but there is a tutorial on the OpenCockpits site that might help too.

Buddy

[Masterploxis]

Hello All,

does somebody has a link to this tutorial on openpockpits.com ? I just found tutorials how to make a concentric rotary switch - but there are no informations about the wiring included.

Regards from Germany
Andreas