Westozy
03-22-2010, 08:27 PM
The recipe: Take one small ten buck Kmart travel clock, remove cover and trim hinges,
Start VCarvePro, draw bezel and faceplate, lubricate throat with a beer,
Add a few grams of PVC to CNC table and hold down firmly,
Spin the cutting utensil until cycle stop, then combine the ingredients over work bench,
Give the assemblies three coats of looking at and add more beer whilst grinning!!!
3568
3569
3570
Cheers, Gwyn
Start VCarvePro, draw bezel and faceplate, lubricate throat with a beer,
Add a few grams of PVC to CNC table and hold down firmly,
Spin the cutting utensil until cycle stop, then combine the ingredients over work bench,
Give the assemblies three coats of looking at and add more beer whilst grinning!!!
3568
3569
3570
Cheers, Gwyn