Doing Duz

[flatlandpilot]

grey pvc, thats grey already and doesn't crack.

http://flatlandpilots.nl/coppermine/albums/userpics/10002/DSCF1651.jpg
http://flatlandpilots.nl/coppermine/albums/userpics/10002/DSCF1645.jpg
http://flatlandpilots.nl/coppermine/albums/userpics/10002/DSCF1646.jpg
http://flatlandpilots.nl/coppermine/albums/userpics/10002/DSCF1647.jpg

[flatlandpilot]

sprayed with airbus grey-blue
http://flatlandpilots.nl/coppermine/albums/userpics/10002/DSCF1652.jpg

sizes:
outside diameter: 10 mm.
inside diameter 7.1 mm. / 3.1 mm. deep.
hole: 4 mm. total height: 6 mm

The top of the duz is 3mm. raised above the panel
The screw top is 1mm. below the duz top.

[Westozy]

Sweet,

Cheers, Gwyn

[riche543]

They look great Flatland, Did you have to change the bit for the rounded/beveled top ?. Would you like to share the dxf or gcode for um..
Cheers
Rich..

[flatlandpilot]

the dxf file are 3 centred circles with a diameter of 4, 7.1 and 10 mm.
yes I had to change the bit, but thats no problem.

for rounding I use this one
http://www.homedepot.ca/wcsstore/HomeDepotCanada/images/catalog/a6405fd6-0907-4a77-a49d-5ffdc6775c7b_4.jpg
http://www.homedepot.ca/webapp/wcs/stores/servlet/CatalogSearchResultView?D=945227&Ntt=945227&catalogId=10051&langId=-15&storeId=10051&Dx=mode+matchallpartial&Ntx=mode+matchall&recN=113330%204294966928&N=0&Ntk=P_PartNumber
(and modified it by cutting off the "guide" / lower part)

[flatlandpilot]

http://flatlandpilots.nl/coppermine/albums/userpics/10002/DSCF1657.jpg