spiro
08-10-2010, 02:26 PM
hello to all
i am using PM and FSX and interfacing with mr Bodnars BU0836X
i have maneged to set up nearly all my pedistal(flaps,spoilers,ecam,rud trim and more)
but i am having a problem with the engine start master 1/2 on ,off and igni/start
i looked into PM fsuipc offsets but are a bit mixed up on witch to use
i tryed 0892 for engine 1 but that only start the ignition n2 25% no fuel injection
dose any one know what is the proper way to set this up so i can turn ignition switch on and start eng1 and eng2 properly as i am a bit confused
kind regrads spiro
i am using PM and FSX and interfacing with mr Bodnars BU0836X
i have maneged to set up nearly all my pedistal(flaps,spoilers,ecam,rud trim and more)
but i am having a problem with the engine start master 1/2 on ,off and igni/start
i looked into PM fsuipc offsets but are a bit mixed up on witch to use
i tryed 0892 for engine 1 but that only start the ignition n2 25% no fuel injection
dose any one know what is the proper way to set this up so i can turn ignition switch on and start eng1 and eng2 properly as i am a bit confused
kind regrads spiro