Best Interface for Throttles???

[skyline223]

Hey Guys,

I am looking for a simple USB interface to use with pots in a throttle quadrant. I need only 6 inputs. Anyone have any suggestions?

[autocadplease]

http://www.leobodnar.com/products/BU0836X/

[ian@737ng.co.uk]

or if you are good with a soldering iron, here's the cheaper option.
i use these in my quads....
http://www.leobodnar.com/products/BU0836/
rgds ... ian

[skyline223]

Thank you very much for the replies guys! This was just what I was looking for.

Thanks again!

Will

[ian@737ng.co.uk]

no worries will.....
and if it helps you out, here's a wiring diagram that may get you started.
http://www.737ng.co.uk/revolution/RSTQ1.pdf
rgds ... ian

[skyline223]

Wow. Fantastic diagram! Thank you again!

[ian@737ng.co.uk]

no worries captain, you will have to 'adjust' the axis inputs because you'll have 3 throttles on the 727,
but it was just to give you some idea of what to do.
you can also use B11 & B12 for trim input if you want.
good luck and regards from wales......

ian



no worries will.....
and if it helps you out, here's a wiring diagram that may get you started.
http://www.737ng.co.uk/revolution/RSTQ1.pdf
rgds ... ian

[tonytor53]

Haegström has a great board. As many inputs as you want.

[Avro748]

I'm glad you're back. I thought that Project Backcountry was dead!