tore pilot
12-26-2010, 05:54 PM
I've been a member since 2008. Have not been active on these pages before.
My project is B737NG cockpit.
Has worked with this for almost four years.
Much is done, I do not have the overhead panel and chairs and some wires are not connected.
Most of the cockpit including TQ is made of Medium Density Fibre Board
(MDF board) pleksiglas and aluminum.
Hardware CPFLIGHT
Software is project magenta and FS2004
There are seven 27 "monitors. This gives a view of 180 degrees round cockpit
Tore
My project is B737NG cockpit.
Has worked with this for almost four years.
Much is done, I do not have the overhead panel and chairs and some wires are not connected.
Most of the cockpit including TQ is made of Medium Density Fibre Board
(MDF board) pleksiglas and aluminum.
Hardware CPFLIGHT
Software is project magenta and FS2004
There are seven 27 "monitors. This gives a view of 180 degrees round cockpit
Tore