mach7
09-24-2011, 08:36 PM
Hello all,
I would first like to thank everyone who has helped me so far in my search for cockpit 'realism'.
A special thank you goes out to 737Nut and Mike Powell for all the help and continued support so far.
Just wondering if there are SIOC scripts readily available to interface with an Open Cockpits USB card.
I am considering going the stepper motor route as opposed to a servo motor to replace the exsisting drive in my engine gauges.
I am also considering using Open Cockpits USB stepper board for the interface.
I am wondering if there are already written scripts for N1, N2, EGT, Fuel flow, etc.
I would first like to thank everyone who has helped me so far in my search for cockpit 'realism'.
A special thank you goes out to 737Nut and Mike Powell for all the help and continued support so far.
Just wondering if there are SIOC scripts readily available to interface with an Open Cockpits USB card.
I am considering going the stepper motor route as opposed to a servo motor to replace the exsisting drive in my engine gauges.
I am also considering using Open Cockpits USB stepper board for the interface.
I am wondering if there are already written scripts for N1, N2, EGT, Fuel flow, etc.