SIOC Group Files [Archive]

Jerrymc3

10-24-2011, 12:46 PM

I have 8 files in the Group/Files in Config_SIOC that are compiling and working fine. Today I added a file for the pmsystems Overhead panel to the Group but when I click run it says file not found. I made sure it was in the SIOC folder and the name was correct. I removed the file from Group/files and the other files compiled just fine again. Is there a limit to the number of files you can have in a group or what else could be causing the problem. I tried this several times with the same result.

Jerry

iwik

10-24-2011, 01:34 PM

Jerry,Sorry but i dont know the limit. Did you try and remove one of the known good ones and leave the new one to see if it is not the file you added causing the problem.LesP.S I have had that before and i think i just resaved the file again and everything was fine. Maybe to SIOC the name has beencorrupted.

Jerrymc3

10-24-2011, 01:50 PM

Just discovered my stupid mistake, left .txt off the filename. Thanks for your input though Les.

iwik

10-24-2011, 01:57 PM

Glad you sorted it out and have a nice day.
Les