SIOC 4 and the SIOC monitor

[pdpo]

Hi all,

the new SIOC has the ability to get a window for each device where we can see the state of the buttons and leds of the
card.
However, when I open this window for my two master cards I can see some buttons in closed state and others which are
closed too in reality doen show green. When I open and close those switches they appear green then. So it looks to me the initial
state of the buttons is not always correct. Do you also see this behavior?

Greetz Peter

[pdpo]

Nobody has tried this???

[kiek]

Hello Peter,
Have not tried it, but I'm not surprised. SIOC has exactly the same problem with some closed inputs that are not dedected by SIOC as closed inputs at start up. If you toggle these switches once they are in sync again.
Groeten,
Nico

[kiek]

Hello Peter,
Have not tried it, but I'm not surprised. SIOC has exactly the same problem with some closed inputs that are not detected by SIOC as closed inputs at start up. If you toggle these switches once they are in sync again.
Groeten,
Nico