Second Displays Card

[Boeing 747 Flyer]

Hello everyone,

I have three master cards connected to a single USBExpansion Card as follows:

J1: In Use (DISPLAY CONNECTED)
J2: In use (DISPLAY CONNECTED)
J3: Not in Use
J4: In Use

So, on other words, there are two displays cards, connected to Master Cards #1 and #2.

The first display card works fine, however, I can't figure out how to configure the second (the one plugged into MC #2).

I have moved the Jumper pin to the "J3" position as per the manual, and have scripted the Displays as displays 16-31, also as per the manual.

Anything I've missed? The displays work fine when tested in Controlador.exe (ie they light up perfectly, so they definitely "work").

Cheers,

Jack

[kiek]

Hi Jack,
You can connect up to 4 Display cards to a Master Card. The numbering is described here (http://www.lekseecon.nl/downloads/Numbering.pdf).

Hope this helps.

regards,
Nico

[fordgt40]

Edited as Nico had replied and given the correct answer, as opposed to mine:p

[kiek]

Extra: The jumper at a Display card determines the position in the row of 4 cards connected to a MC. You can put a card wherever you want (no special connect order).

Note that since SIOC 4.0 there is a tool called SIOC_Monitor. If you push the button ALL ON you can easily check whether the Display card works or not and by sending a number to a digit you can find out the numbering as well.

Nico