Helimike44
02-24-2014, 07:25 AM
G'day
I am looking into constructing a simple GA interface panel that I intend to form around the Saitek yoke I have.
Ive done a few MDF builds before, but the thought occurred, what if I make the MDF section into a mould suitable for a poured resin to form in.
Has anybody attempted this and are there any tips and tricks.
Thanks
I am looking into constructing a simple GA interface panel that I intend to form around the Saitek yoke I have.
Ive done a few MDF builds before, but the thought occurred, what if I make the MDF section into a mould suitable for a poured resin to form in.
Has anybody attempted this and are there any tips and tricks.
Thanks