krosa
10-12-2014, 12:18 PM
Hello JL and everyone,
I'm adding motorized trim wheel to my pedestal (now it's just a sort of placeholder wheel with no motor) and I would like to understand which solutions are currently available and "plug and play" (if any).
It would be nice to share some user experiences to understand pro and cons of each solution.
Last but not least I was considering also the idea of building a custom solution and writing a custom software that get & set the trim value and control the motor of the wheel: you consider this viable? I'll need some support by your side or I can stick with default FSUIPC trim offset? I would like to make it compatible with FSX and P3D or at least just P3D.
Thank you very much again.
Stefano
I'm adding motorized trim wheel to my pedestal (now it's just a sort of placeholder wheel with no motor) and I would like to understand which solutions are currently available and "plug and play" (if any).
It would be nice to share some user experiences to understand pro and cons of each solution.
Last but not least I was considering also the idea of building a custom solution and writing a custom software that get & set the trim value and control the motor of the wheel: you consider this viable? I'll need some support by your side or I can stick with default FSUIPC trim offset? I would like to make it compatible with FSX and P3D or at least just P3D.
Thank you very much again.
Stefano