mcdufall
11-10-2014, 07:34 AM
Hi
I now have my Home-built TQ almost finished. I am ready to make the throttle handle (just aluminum bars at the moment) I have attached a sketch and I believe I have the proportions about right. However I have seen so many different measurement around that I am somewhat confused! The sketch is "full size" on A4 and the dimension 'x' is about 170 mm. Can anybody confirm the dimensions w, x, y and z :)
Regards
Mike
I now have my Home-built TQ almost finished. I am ready to make the throttle handle (just aluminum bars at the moment) I have attached a sketch and I believe I have the proportions about right. However I have seen so many different measurement around that I am somewhat confused! The sketch is "full size" on A4 and the dimension 'x' is about 170 mm. Can anybody confirm the dimensions w, x, y and z :)
Regards
Mike