Cannot read value from JeeHell by fsuipc offset

[tonpp]

Hello everyone.
This my first post.I have question about how to read value from JeeHell this difference from PMDG? Usually I use Link2fs for read offset to check value but I cannot read any value from offset JeeHell.What I do wrong? Need to config? Please advise to me.

Thank you.

[tonpp]

Hello everyone.
This my first post.I have question about how to read value from JeeHell this difference from PMDG? Usually I use Link2fs for read offset to check value but I cannot read any value from offset JeeHell.What I do wrong? Need to config? Please advise to me.

Thank you.

10195
I try to open FSUIPC Connect this show "Not compatible with FSX/P3D......"

[OmniAtlas]

Did you run configure.exe (tick This computer is running FS9/X), and then StarterFSX.exe?

[tonpp]

Did you run configure.exe (tick This computer is running FS9/X), and then StarterFSX.exe?

This my step after open computer
1.Open MSFX and select JH A320.
2.Go to C:\A320FMGS and open configure.exe and select This computer is running FS9/X.
3.StarterFSX.exe
4.Go to C:\A320FMGS\FMGS Server and open FSUIPCconnect.exe but same result.
Is this correct step.

Thank you JeeHell for your support.

[jeehell]

FSUIPCconnect is not used to have FSUIPC hardware controls. You must not use that with FSX/P3D
You just have to install FSUIPC supprot during installation. Then, starterFSX will launch hardwareConnect which adds the FSUIPC support.


regards,
JL