Touch screen with pm systems

[spiro]

Hi

I have set up a touch monitor for my overhead it works fine but there are no lables on the panels like hyd,elec only on the fire handels,also the buttons have no on,off indications.

is there something in the config file i have to set to show them??

regards

[PeterH]

Hi

I have set up a touch monitor for my overhead it works fine but there are no lables on the panels like hyd,elec only on the fire handels,also the buttons have no on,off indications.

is there something in the config file i have to set to show them??

regards


Hi

have as well a touch screen setup for Pmsystems. The so called "Sixpacks" are there and fully functioning, but you need to zoom out from the overhead panel. They are outside the panel, about where the cut off switches are located.

I however have got the sixpacks on my MIP.

Hope this helps

best rgds

Peter