installing rudders with jeehell

[udaanaviation]

i have been trying for sometime now ; however am facing issues with trying to get my rudder pedals from cockpitsonic to work after having successfully configured them in ehid.i was hoping you could help me because cockpitsonic is unable to. The issue i am facing is in fmgs_config , rudder pedal physical input does not make the control axis appear and i am unable to see it in dropdown list either.please let me know how to fix this and enable me to use my equipment

[jeehell]

Can you get the EHID device ID for the rudder pedals? (you can use teh EHID test soft or maybe the EHID calibration tool can give you that). If my software does not detect the rudder, then it means it does not have the proper ID assignement (according to Cockpitsonic specs).

[udaanaviation]

am attaching list of id's for various devices as i see on ehid calibration tool dialog window. i think the last one i am unable to calibrate as i havent connected two pedals via the metal rod.

brake left cap (0x50705301)calibrated
brake right cap (0x50705302)calibrated
0x50705403 (0x50705403)calibrated
brake left f/o(0x50805301)calibrated
brake right f/o (0x50805302)calibrated
0x50805403 (ox50805403) not yet calibrated


appreciate your help as it is the only way i can probably get my equipment to work.

[jeehell]

The IDs are correct.
Did you install EHID support when you installed my software?
You have EHID with A320 xml setup from uwe Schneider correctly installed?
You do not run FMGS config in parallel to the main FMGS software?

JL