digidax
02-23-2017, 10:51 AM
Hi,
yesterday evening I was training touch and go on DUS/EDDL RWY 23L for 5 times. During the whole simulator session and during all phases of flight AP disengages by themself without any reason I can figure out. This problem I have since B46. The ECAM shows AUTO FLT AP OFF and the warning light and sound occurs. No other message in ECAM or STS / RCL. Then pressing AP1 button and AP engages. Sometime after a few seconds it disengages by a ghost's hand. So pressing AP1 button again. After some times, the pilot wins and the AP is for some times enabled. Then randomly, the show begins again, everytime, during climb, decend, cruise, land. But there is a small detail maybe. During some time in this session, I have disabled NAV mode and have controled the flight by operated SPD, HDG and ALT input on the FCU. During this mode, the AP has not switched off by themself. And on some session, this problem doesn't occur. All bin files in NAVDATA folder are generated new. P3D hotfix is also installed, also deactivated AS16 brings no calm.
I thought to have read that some other here have also the same problem. Maybe also a solution?
best regards, Frank
yesterday evening I was training touch and go on DUS/EDDL RWY 23L for 5 times. During the whole simulator session and during all phases of flight AP disengages by themself without any reason I can figure out. This problem I have since B46. The ECAM shows AUTO FLT AP OFF and the warning light and sound occurs. No other message in ECAM or STS / RCL. Then pressing AP1 button and AP engages. Sometime after a few seconds it disengages by a ghost's hand. So pressing AP1 button again. After some times, the pilot wins and the AP is for some times enabled. Then randomly, the show begins again, everytime, during climb, decend, cruise, land. But there is a small detail maybe. During some time in this session, I have disabled NAV mode and have controled the flight by operated SPD, HDG and ALT input on the FCU. During this mode, the AP has not switched off by themself. And on some session, this problem doesn't occur. All bin files in NAVDATA folder are generated new. P3D hotfix is also installed, also deactivated AS16 brings no calm.
I thought to have read that some other here have also the same problem. Maybe also a solution?
best regards, Frank