Offset for landing gear and brake panel

[Andykap]

I am looking for the offset for the landing gear mechanism and the brake panel landing gear led status.
Any idea?

[michael1508]

Take Offsets from FSUIPC directly for mechanism and LED configuration

[Andykap]

Thanks Michael, I did not even looked at FSUIPC but at the offset provided by JeeHell.

[Andykap]

Also, I am using Mobiflight with the following offset:
0BE8 - 0 - UP
0BE8 - 16383 - Down.
None works. I also tried the EventID to no avail.
is this working for anyone? If so are you using the same values? These values works with the default aircrafts, but no Jeehell.

Edit... I got it working, the Arduino board I was using had issues, could be because it was excited about the new year :)

[michael1508]

Hi Andy,

great, it's working for you now. I assume, you are not on version B49 yet? With B49 the routine changed! You need to take the Jeehell offsets now:
78ED/1 Byte =>value 81 for Up, 82 for Down

So do not be irritated when updating to B49 :-)

Best,
Michael

[Andykap]

Thanks. I got it working and setup the LED for red and green on the brake panel.