wchambers
11-20-2004, 01:41 PM
I just received my 737 gear handle and wired it up the my 0/8/8 Phidget - the Phidget sees it and recognizes it but when I assign it the "gear handle" option (which is the only appropriate assignment I saw) and run it - the gear just move back to their original position - i.e. if they are down - they move up and then back down - any suggestions would be greatly appreciated. The gear handle assembly uses what appears to be a two way switch with a piece of metal exposed on the top that when contacted depresses a switch underneath. Thanks for you time.
Will
Will