AML switches

[imported_Nihad]

Question I am using momentary AML switches on my MCP and was wondering if its not possible to give this switch 2 commands so it can stay on in FS2004 when pushed and when pushed again turns off
Any help on this would be appreciatte it

regards,

Nihad

[imported_MattO]

Depends on what software you are using. I e.g. use PM and the following code works for me with momentary switches, such as the AML switch.

[FCU_SET_LOC]
offset=4F2
Length=4
FSType=Digital
OffValue=0
OnValue=28

Hope this answers your question.

Matt O.

[imported_Nihad]

Hi Matt,

I am trying to figure out all this so sorry about that.
With the code u just added in your reply do u use that in the fs2phidget? and yes I own the PM software too.
If not if u could please tell me where this code needs to be added.

regards,

Nihad