Gear instructions

[michelmvd]

Hello,
I'm looking for the instruction you have to put in FS2Phidget (equal to "G" keystroke). Which offset can I use to activate single switch ?
Many thanks for most appreciated help
Michel

[PeterH]

Hi Michel,

the FS offset: for Gear up dec. 66079 = hex 1021F
for Gear down dec. 66080 = hex 10220

Hope this is what you are after

Best rgds

Peter

[michelmvd]

Thanks a lot then it looks that I will need to swiches in the gear box
Greetings
Michel

[Bob Reed]

You could use one offset for when the switch is on and the other for when the switch is off. That would give you your 2 offsets as well.

[michelmvd]

Hi Bob, hmmmm can this be done with FS2Phidget ?
B. Rgds
Michel

[alandyer]

Michel,

One offset (gear handle).

Two Values for Offset (gear up and gear down).

One switch with two Values (on and off).

Use Fs2Phidget (or any solution supporting Digital Input) to:
assign Gear up Offset value to a switch's Off position
assign Gear down Offset value to a switch's On position.

Gear Offset: 0BE8
Offset values: 0 = Up, 16383 = Down

Regards,
Alan.

[michelmvd]

Okidoki Alan, its is working.
Many thanks for your super support.
Ciao
Michel