GC 737 EICAS value slow bug!!!

[dcutugno]

Hi, i have problems with the eicas screen (737) values, i noted that they are updated to slowly, for example when i start theEngine at N2 46% the starter switch returns to off, if you monitor the 737 default panel and PMsystems it's is triggered correctly, but in eicas page N2 increasing i very slowly (other values also, EGT etc.), i have tried all wideclient settings, but is not a problem with it, infact i discovered that it happens also in the same machine as FS is running!

This is very strange, 'cause i want to monitor the N2 values correctly, and when my solenoid is triggered, N2 values is still behind!

Can you look further?

**mailed to PM support!

[dcutugno]

Got a reply from PM, playing with those values seems to solve the problem:

N1StartupDelay=0
N2StartupDelay=0

[Bob Reed]

Thanks for sharing the response! It is a good idea to share what you hear from PM.

[dcutugno]

A correction about 46% value,
Starter cutout is approx 46% N2 -3/4/500; 56% N2 -NG's.

[Hans Krohn]

Got a reply from PM, playing with those values seems to solve the problem:

N1StartupDelay=0
N2StartupDelay=0

Hi,
which ini? PM-systems or GC?

Thanks,
Hans

[Bob Reed]

The ini file for the copy of PM that runs the ECIAS.....

[dcutugno]

No, in the aircraft type .txt in GC or CDU it depends if you have set Type=CDU or not.