Michael Carter
04-17-2007, 02:16 PM
I finally got around to building a correct RT box for the MIP.
The other RT box was built of scraps I had laying around just to fill up the hole.
This one is made of 1/2" AC cabinet grade plywood. It's detachable as I'd never be able to get the whole thing into the room in one piece.
The first center support leg I had upder the MIP has been cut away from the front edge, but is still helping to support the center of the MIP, just farther back underneath where it cannot be seen.
http://img69.imageshack.us/img69/2517/cockpit7sc5.jpg
The other RT box was built of scraps I had laying around just to fill up the hole.
This one is made of 1/2" AC cabinet grade plywood. It's detachable as I'd never be able to get the whole thing into the room in one piece.
The first center support leg I had upder the MIP has been cut away from the front edge, but is still helping to support the center of the MIP, just farther back underneath where it cannot be seen.
http://img69.imageshack.us/img69/2517/cockpit7sc5.jpg