Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11
  1. 02-26-2010, 04:45 PM #11
    fweinrebe
    fweinrebe is offline
    Heli Builder
    Join Date
    May 2008
    Location
    Earth
    Posts
    288
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Your CNC Machine..

    I had the time to take some photos of the nearly completed CNC. It is a mix between the 'jgro' and a Rockcliff Model 'A'.
    Attached Images Attached Images
    Fritz -> Helicopter Cockpit Builder
    (FSX | TH2Go | Arduino | Air Manager Avionics | CNC)
    Reply With Quote Reply With Quote
  2. Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
    Thanks wannabeaflyer thanked for this post
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Similar Threads

  1. New CNC Machine
    By mondo50m in forum CNC Discussion
    Replies: 7
    Last Post: 09-07-2010, 02:16 AM
  2. New Machine!!
    By mondo50m in forum CNC Discussion
    Replies: 2
    Last Post: 08-06-2010, 09:12 PM
  3. What do you think of this CNC machine?
    By twisted8 in forum CNC Discussion
    Replies: 5
    Last Post: 07-27-2010, 02:15 PM
  4. New CNC Machine
    By mondo50m in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 04-13-2010, 08:13 PM
  5. Looking for CNC machine
    By AndyT in forum Westozy's Mechanical Engineering
    Replies: 36
    Last Post: 01-26-2009, 11:58 PM