Progamming help with FSBus dll

[sgaert]

I have 11 IO Boards working, there is no error.
David and i have the new DLL for testing.
Official it will release after the 20.Feb.2011.

Stefan

[shearder]

This is very strange. I can't think of something that is doing this. Could it be the setup of my serial port? or W7? or something affecting it?

I am lost.

[RobiD]

Hi Sean,

I only have two IO boards working faultlessly. I did have the issue of resets on the board, but changed the fuse bits as you have done, and I have not had a problem since. I use many rotary encoders without problems.

If it has only just started doing this, the board may have developed a cracked track if it has been moved a lot, or bent or twisted a bit.

Looks like some detective work, but there will definately be a fault somewhere, perhaps even a dry solder joint. My next step would be to pull the board out, grab your multimeter and start testing. Maybe even put the board under a little pressure so if there is a crack it would be easier to pick up with the meter.

Just my thoughts.

David

[RobiD]

maybe, you write that the values are -32765 to 32765.

How would I write it that way in the code?

When ever the relative bearing data goes into a -ve number, the 'buf' error appears.

[RobiD]

Ok edit that line to that.
ADF1RelDataIn = val + 32765;


That was the reason why i ask you to fly a lot of 360th. I expected that error.
We need something like a counter that count how many full cirrcles the Data input turn. With that we can add full circle steps to the output.

That is a good homework for us.

Stefan

Had any thoughts on this one?

I wouldn't know where to begin to add a counter, let alone what to do with the data after that. Thank god you're here.

[sgaert]

i have some ideas, but not the time to code that.
Also i don´t know the effect if you enter a new frequenz.

[RobiD]

Happy to wait until you have time Stefan. I just appreciate the time you are giving.

[sgaert]

Hehe, new Idea, try it self.
Here is my Idea.


have fun,

Stefan

[sgaert]

As info Version 3 is released.
download

Have fun and read the manual for the changes!!

[shearder]

As info Version 3 is released.
download

Have fun and read the manual for the changes!!

Thanks Stefan. Anythig new that would be good to take special note of?