Results 1 to 2 of 2
  1. #1
    10+ Posting Member
    Join Date
    May 2008
    Location
    Sao Paulo - Brazil
    Posts
    20
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Boeing and Embry-Riddle use PM . What for?

    Does anybody have any idea why these companies use Project Majenta? If for professional use , are they satisfied ? Like I said before, there are some mistakes that is impossible not noticing , beginning with engine start where that red mark stays in EGT after engine stabilizes( Is that so difficult to eliminate?) . Following that, the N1 green dot in N1 ARC that should always represent the takeoff maximum continuous thrust , when selecting a temperature for a reduced takeoff ( R-TO) , the green dot follows N1 reduced setting (wrong) . Sorry guys , but for proffesional usage I don磘 recommend.

  2. #2
    300+ Forum Addict BlackWidow's Avatar
    Join Date
    Dec 2006
    Location
    Tehacahpi CA, USA
    Posts
    437
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Boeing and Embry-Riddle use PM . What for?

    Just to throw this out there but what if the versions that Boeing and Embry-riddle use are not the exact same versions that you have. If I was a multi billion dollar company and asked a software company that I had purchased from to fix a few errors i bet it would get done. That does not mean that it gets fixed for everyone else. just my .02 cents I could be totally wrong.
    Mike G.

Similar Threads

  1. boeing 747-737
    By azza2010 in forum Welcome to MyCockpit New here? Introduce Yourself!
    Replies: 1
    Last Post: 11-24-2010, 02:29 PM
  2. Boeing 757 or 767 MIP Kit
    By edo17982 in forum Off Site Articles For Sale
    Replies: 0
    Last Post: 06-08-2010, 10:12 AM
  3. Boeing 737
    By KLM077 in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 10-15-2009, 12:40 PM