Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
  1. #11
    150+ Forum Groupie
    Join Date
    May 2006
    Location
    london england
    Posts
    177
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: which servos do you use? and which gear?

    Cheers Rob , Thought there had to be a catch somewhere LOL never thought about the return to center issue , good spot and good info for the future when looking to make DIY servo instuments.

  2. #12
    500+ This must be a daytime job 737NUT's Avatar
    Join Date
    Feb 2006
    Location
    Indianapolis, IN
    Posts
    760
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: which servos do you use? and which gear?

    Also, another caveat is the opencockpits servo card is only 8bit Need to find a 10bit or preferably 12bit servo control. They have them for R/C stuff, just not us.

    Rob

  3. #13
    500+ This must be a daytime job



    Join Date
    Jul 2013
    Posts
    917
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: which servos do you use? and which gear?

    I suppose it depends on the degree of accuracy you are expecting on your gauge movement. 8 bits is fine for the gauges on my overhead.

    David

Page 2 of 2 FirstFirst 12