Help Please

[johnnyg]

Is this picture figure 5 it don't say that anywhere in my manual but would this be the correct way to set the settings?

[johnnyg]

I can hear and feel the motors wanting to turn by holding the shafts and using these settings but they dont move. Are these settings correct and what Else do I need to move them and how?

[Perik]

johnnyg,

Have you tried to wire according to Fig. 5?
I suggest you concentrate on just one stepper - for instance X-motor
pin 16 and pin 1.
What have you done on the "Motor tuning" page?

About the fourth axis (A).
Use A - not C. Mach3 default show only X,Y,Z and A (fourth axis).

I must say I have no experiece with this controller and I don't have your
manual - just the reference from the link I'm pointing to.

Have you made a deep dive into the Mach Install manual:
http://www.machsupport.com/docs/Mach...all_Config.pdf
A lot of good reading

[johnnyg]

Here's the manual that was emailed to me.

[Perik]

Johnnyg

You'll have to look at at Fig. 6 as well and check mark "Enable1" - enable X-axis (pin 4)