Results 1 to 3 of 3
  1. 03-26-2018, 10:35 AM #1
    hobday
    hobday is offline
    10+ Posting Member
    Join Date
    Jan 2018
    Location
    Deutschland
    Posts
    10
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Config pitch trim not in T.O range - different indications -

    Hi all,
    I have a difference value between the pitch trim indication on the wheel (zero) and on SD which indicates 4.0 nose up. The trim wheel a Skalarki one with motorized trim is well calibrated and FMGS is up to date also the Profiler. The aircraft commutes in speed and altitude. The difference remains. Should be something of weight calculation but on the runway the values should be match e.g. trim wheel on zero and SD indicates also zero (?). The P3D version is 4.2... Thank you for help... Regards Werner.
    Reply With Quote Reply With Quote
  2. 04-26-2018, 07:41 AM #2
    Totti
    Totti is offline
    25+ Posting Member
    Join Date
    Jul 2016
    Location
    Hamburg
    Posts
    39
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Config pitch trim not in T.O range - different indications -

    Hello Werner,
    I have the same problem. Did you fixed it?
    Regards,Thorsten
    Reply With Quote Reply With Quote
  3. 04-27-2018, 08:40 AM #3
    hobday
    hobday is offline
    10+ Posting Member
    Join Date
    Jan 2018
    Location
    Deutschland
    Posts
    10
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Config pitch trim not in T.O range - different indications -

    Quote Originally Posted by Totti View Post
    Hello Werner,
    I have the same problem. Did you fixed it?
    Regards,Thorsten
    Hi, I restored a backup which I did before fortunately. The failure in pitch trim disappeard and I donīt know no the reason... that the aircraft commutes I assume that happens when the aircraft goes to fast from descend/climb phase to ALT CRZ so if I pay a little attention this weird behavior no longer takes place... Regards Werner
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »