how to set " SPOT PLANE view" button

[carlos hermida]

Hi for all,

I trying to set a button in CONTROL section of PM Instructor to make possible to use the "S" keypress from keyboard that cycle views to SPOT PLANE. This will be to help me when I start a pushback.

I think that the offset is that below (if i am not wrong) but no way to make it work !!

8320

1

Byte value, the view mode in the currently selected window (read/write):>> FS2004: 1=cockpit, 2=virtual cockpit, 3=tower, 4=spot plane, 5=top down>> FS2002: 0=cockpit, 1=virtual cockpit, 2=tower, 4=spot plane, 7=top down>>

[sas550]

Let me first say that I don't have the instructor station so this might not be of any help. But I was struggeling with some hardware buttons on my fo yoke for the view modes. I use iocards and sioc for programming the buttons. But it's the same offsets used. I used 3110 length4 and control number 65567 for next_view_mode and control number 65749 for prev_view_mode. Try them.

[carlos hermida]

Thanks SAS550, will try that tomorrow !

[carlos hermida]

Great SAS550, it worked perfectly !! by the way do you know the offsets for ZOOM IN and ZOOM OUT to use with this VIEWS?


Best regards,

Carlos Hermida

[sas550]

If you check the "List of Fs2004 controls.pdf" file that comes in the fsuipc.zip you'll find all controls that can be used with offset 3110.
This goes for the different zoom controls.

ZOOM_1X

65550

ZOOM_IN

65655

ZOOM_IN_FINE

65754

ZOOM_MINUS

65718

ZOOM_OUT

65656

ZOOM_OUT_FINE

65755

ZOOM_PLUS

65719

ps. I haven't tried them but I can't see any reason why they shouldn't work