Results 1 to 7 of 7
  1. #1

    Wiring Optical Encoders

    Hi Guys,

    Im changing from mechanical to optical rotary encoders and was wondering if anyone using optical encoders could post a close up picture of hey they wired in the pullup resistors.

    Thankyou
    Gary

  2. #2
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,883
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    What optical encoders are you using. Brand name and part number? Oh, and what interface are you going to use it with
    '

  3. #3
    Hi Matt,

    Im going to use the Grayhill 61C11-01-08-02 encoders with the FDS-G1. They have a 2 bit output so should work. Im trying to keep the wiring as neat as possible so was considering if it would be easier using terminal blocks and running 2 seperate wires for each output - one to 5v with resistor the other direct to the interface ,but I would like to see how others are doing it also.

    Thanks
    Gary

  4. #4
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,883
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I'm not sure if this is helpfull, if not maybe someone else can jump in here. Check out these drawings:

    http://ifsbi.org/public_ftp/RotaryWiring.gif

    http://ifsbi.org/public_ftp/62GB_Scematic.JPG

    Hope this helps....

  5. #5
    Hi Matt,

    I have the schemetic for the encoder. Before soldering the resistors into the +5v I just wanted to see a photo of what others have done, to be sure Im actually on the right track. Electronics is not my specialty to say the least

    Gary

  6. #6
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,883
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I know what you're going through... I'm not a electronics expert myself, but eventually I just dove in. Maybe this schematic is not so threatening


  7. #7
    Thanks for the schematics Matt,

    I Greatly appreciate your help.

    Gary

Similar Threads

  1. Selling my 737 Collimating Optical System
    By mattford1 in forum Video Interfacing and Hardware
    Replies: 0
    Last Post: 08-03-2009, 11:15 AM
  2. Optical Encoders
    By gblock in forum OpenCockpits General Discussion
    Replies: 0
    Last Post: 01-19-2009, 10:55 PM
  3. Rotary Encoders parrallel wiring?
    By Tomlin in forum I/O Interfacing Hardware and Software
    Replies: 12
    Last Post: 11-15-2008, 03:32 PM
  4. Optical Encoders with Phidget????
    By imported_MattO in forum FS2Phidget Users
    Replies: 6
    Last Post: 03-15-2005, 02:50 PM