Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Push to Talk

  1. #11
    300+ Forum Addict NicD's Avatar
    Join Date
    Aug 2006
    Location
    Hobart, Australia
    Posts
    404
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I agree ... I'm just trying to get my A/P disconnect going
    Nic D'Alessandro
    737NG builder (Hobart, Australia)
    http://simsation.com.au

  2. #12
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Dec 2007
    Location
    Whitby
    Posts
    5
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Q: It means the circuit is always closed unless the button is pushed so unless you can reverse the function in the software, you'll have a hot mic the whole time you're on-line.

    A: This is not an issue as phidget software has an invert button which allows you to reverse the on/off state of the button through the Phidget software.


    Q: Why not use the original PTT on the yoke?

    A: Because I am using the PTT for side views eg) when real PTT on yolk rocked on the up side it gives one side view and when rocked down it gives the other side view.

Page 2 of 2 FirstFirst 12

Similar Threads

  1. How can I make COMM TEST button PUSH to TALK button ???
    By Nick1150 in forum OpenCockpits General Discussion
    Replies: 2
    Last Post: 09-29-2010, 09:50 AM
  2. need help on how to make a Push to talk Button on Yoke
    By 388TH_A in forum I/O Interfacing Hardware and Software
    Replies: 11
    Last Post: 06-29-2009, 06:31 PM
  3. Quick Q, on push to talk
    By Geremy Britton in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 10-22-2007, 12:37 PM
  4. Push-To-Talk Button
    By flightdeck in forum I/O Interfacing Hardware and Software
    Replies: 11
    Last Post: 08-16-2007, 02:08 AM