PMRJ PDF Display Question

[Tim]

Hi Denis,

My sim is on another computer so I will again try this from memory.

In FSUIPC Buttons and Switches tab:

Click rescan then press the button you want to assign. You should see it identified.

On the right side of the box, place a check in the FS and PM boxes.

In the drop down box, scroll down until you see the PM TCAS functions. Click on the one you want.

Close the Buttons and Switches tab and see if you can control TCAS.


Not all PM functions are in the drop down box. Pete Dowson added a drop down function called "Assign By Pram" or assign by parameter. There is a list of PM parameters on the PM documentation page.

I'll look at this again when I can get a minute to turn on the sim. I hope this explanation can point you in the right direction.

[Denis]

Hi Tim,

Thanks for your help. This IS my problem : assign by param : I don't find a way to have it working. The other ways are OK, but only a fiew of them are for PMRJ. I've tried a lot of things, but it never works, so I need help : where can i find an exemple of the offsets and params for PMRJ and PM systems.

Best regards

Denis

[Tim]

Denis,

Look in the FSUIPC Advanced User's Guide. The Guide should be in the folder where you installed FSUIPC.

Here is a quote from Pete Dowson:

" .... there's also already a special FSUIPC control, documented in the FSUIPC Advanced User's guide, called PM GC Controls (by param) .... "


Take a look there and see if you can find what you need. If not, just keep asking. That's what this site is for.

[Tim]

Denis,

Look at page 27 of Advanced User's Guide.

Here are the TCAS parameter numbers:


50 TCAS Off
51 TCAS Alt
52 TCAS CallSign
53 TCAS All
54 Toggle TCAS Off/Alt


One other note. I do not believe all the PM offsets or parameters are identified as specific to the RJ. Sometimes you just have to try one and see if it will work.

[Denis]

I Tim,

Thank you for your help, i can now use the PM GC Commands !

But the PM GC Keys is still mysterious for me (and some functions are only available in that way.

FSUIPC.INI shows that : 38=P175,22,C2996,0 and does nothing

Have you any idea which way i could send a "T" value ?

Best regards

Denis

Denis,

Look at page 27 of Advanced User's Guide.

Here are the TCAS parameter numbers:


50 TCAS Off
51 TCAS Alt
52 TCAS CallSign
53 TCAS All
54 Toggle TCAS Off/Alt


One other note. I do not believe all the PM offsets or parameters are identified as specific to the RJ. Sometimes you just have to try one and see if it will work.

[Tim]

Hi Denis,

Sorry for a late reply on your question.

You have the Button assigned correctly. Your problem is you have not told it which key to send.

38=P175,22,C2996,0 Change the 0 to 84, which is the parameter for the letter T.

Look in the FSUIPC Advanced Documentation. I believe around page 25 or so, there is a section which list the parameters for Letters.

Hope this helps.