Results 1 to 5 of 5
Thread: 50k Ohm Slider Pot
-
11-28-2008, 03:01 AM #1
- Join Date
- Nov 2008
- Location
- Usa
- Posts
- 165
50k Ohm Slider Pot
Hi all
just wondering if a 50k Ohm linear Slider Potentiometer would work with leo Bodnar's Universal Joystick Controller BU0836X
Cheers
Rhys
-
11-28-2008, 05:21 AM #2
It should work. I do not see any problems with it.
God's in command, I'm just the Pilot.
http://www.geocities.com/andytulenko/
-
11-28-2008, 03:53 PM #3
- Join Date
- Nov 2008
- Location
- Usa
- Posts
- 165
Thanks AndyT
The reason I ask is the control rods on my heli simpit have 2 horizontal rods for the cyclic and 2 rods under the cockpit floor for the pedals.
linear Slider Potentiometers would be the easiest setup just fix the pots to the cockpit and attach and fix the rods to the slider pots
Rhys
-
11-28-2008, 07:33 PM #4
As long as the pots have enough travel you will be good to go.
God's in command, I'm just the Pilot.
http://www.geocities.com/andytulenko/
-
11-28-2008, 07:59 PM #5
- Join Date
- Nov 2008
- Location
- Usa
- Posts
- 165
I only need about 60mm "30 forward 30 back" figure I will get a 100mm travel lenght to be on the safe side.
Rhys
Similar Threads
-
servos and slider pots.
By booah in forum Phidgets & Cockpit Simulator BuilderReplies: 24Last Post: 02-27-2009, 02:05 AM -
Slider pot travel
By nosecone in forum General Builder Questions All Aircraft TypesReplies: 3Last Post: 12-04-2008, 09:20 PM -
controlling engine one and two reversers from one slider??
By steve diamond in forum I/O Interfacing Hardware and SoftwareReplies: 5Last Post: 11-14-2006, 08:18 AM -
Help assigning collective to slider for heli
By lineman55 in forum Phidgets & Cockpit Simulator BuilderReplies: 15Last Post: 08-05-2006, 05:48 AM -
linear slider pots to use with phidgets 8/8/8/
By steve diamond in forum Phidgets & Cockpit Simulator BuilderReplies: 3Last Post: 03-28-2006, 05:53 PM
Hello, I have MCDU, Glare and now OVH from SKALARKI and i use JeeHell software. MCDU and...
Overhead