A320 FMGS B53

[pete_fuss]

Yes,mee to !regards Pete

[asessa]

mee to, today LIML-EDDF give me about 1040 miles because some point was located in wrong position

[Beaufort]

Same at me. MORA.bin missing, Wayponts displaced, Database stops at 49%. Both P3Dv4 and P3Dv5, B53.1.0, AIRAC2006. EDIT: Went back to 53.0.1, problem disappeared with AIRAC2005, but appears again with AIRAC2006. Seems to be a Navigraph problem?

[startrail]

The last Navigraph DB 2006 build stops at 49%. Anyone with this? Regards

Same here but restarted computer and it works.Mike

[Leonidas]

Same here but restarted computer and it works.Mike

Haha, same to me, but database may be corrupted, isn't it?

[Beaufort]

Haha, same to me, but database may be corrupted, isn't it?

X-checked it: Yes, after reboot Database loads completely into MCDU, but waypoints are still displaced, so (Navigraph -?-) database seems to be corrupted. To be exact: Some, but not all waypoints are displaced, when I load a Coroute transferred by CorteManager4JH or when I put the route with airways into the MCDU manually. But when I clear the displaced waypoints and put only them, but not the airway manually into the flightplan in the MCDU, the waypoints appear correct. This appears as long as I have navrecord.dat with AIRAC2006 from Navigraph active, in this case MORA.bin is missing, when I let A320FMGS build new bins. The problem is gone when I have navrecord.dat with AIRAC2005 from Navigraph active. In this case the bins are built with MORA.bin.

[jeehell]

There seems to be some issues in the AIRACR 2006. I will report that to Navigraph.You can circumvent the issue by actually using AIRAC 2005 as DB1 and AIRAC 2006 as DB2 instead.

[jeehell]

I put a full update on the updater which should fix the issue. NOt 100% tested so I hope it works, please report any issues such as procedures or waypoints missing etc...

[startrail]

Haha, same to me, but database may be corrupted, isn't it?

Yes it is. The issue is from Navigraph. It is operational but waypoints are misplaced.

[romeow]

I put a full update on the updater which should fix the issue. NOt 100% tested so I hope it works, please report any issues such as procedures or waypoints missing etc...

Hi JH,

I would like to go on with version 52.5.6 and I don't mind to use DB of AIRAC 2005 for a while. Do you think that Navigraph will update/correct their current navrecord.dat or do we have to wait until AIRAC 2007? Or is it mandatory to install your full update to be able to use all future AIRAC from Naivigraph?
Regards
René