A320 FMGS beta 26

[jeehell]

If you don't use it directly and your hardware modules don't either (which they shouldn't if linked to hardware modules software), then you don't need it. You can simply delete the fsuipcmodule.dll (or rename it without dll extension to be sure at first).

JL

[Leonidas]

What are FTD2XX_NET.dll and interfaceITAPI.dll for?

[jeehell]

InterfaceIT.dll is used by JeehellIIT.dll to communicate with FDS board. It is not loaded by hardwareconnect.
FTD2XX_NET.dll is probably used by fscockpit.dll to communicate with fscockpit hardware. It is not loaded by hardwareconnect either.

[chris68]

Hello Guy's
yesterday i made some flights and i have still the same problem as i mentioned before once that the
speeds falling under the critical speed that the AP is switching off. This happens from almost every flight in the landing phase. My targetspeed will not kept very accurate (+/-20) when the gap to this speed is very small.
Beside of the engine acceleration: what flightmodel you are using. I tried the iFDG A320 model and Project A320 in FS2004. May be there is further configuration necessary.

Thanks a lot

[Leonidas]

InterfaceIT.dll is used by JeehellIIT.dll to communicate with FDS board. It is not loaded by hardwareconnect.
FTD2XX_NET.dll is probably used by fscockpit.dll to communicate with fscockpit hardware. It is not loaded by hardwareconnect either.

You mean InterfaceITAPI.dll
Thanks JL

[Leonidas]

Ok you have a lot of interfaces in there. Can you try the following:
- use one hardware interface only at the same time. Do that for each, and see if it lags or not.
JL

It lags for every interface. It lags even when I remove all interfaces (by clicking a button on software MCDU, you can see a 2 or 3 seconds delay!). The most annoying are from thrust levers and especially FCU.

[jeehell]

Hmm in that case the most probable case is widefmgsserver or widefmgs clients introducing system lag.
I want to rework that part, but it may take some time ...

JL

[jeehell]

Hi all,

apparently the thread was accidentally closed down (probably an error from myself ...) sorry for that, it's back online fro errors, bugs etc...

JL

[stefangr]

Hi JL,

from time to time I keep getting "Access violation" errors, mostly from OVHD, today as well from ND which caused the ND to shut down. Do you need any more details or logs or this is a "user error"?

Thanks
Stefan

[jeehell]

Hi Stefan,

I hunt these errors regularly, but most of them are tricky. Next version will already have some of them corrected (not all...).

JL