Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14
  1. #11
    150+ Forum Groupie Tom_G_2010's Avatar
    Join Date
    Mar 2011
    Location
    Central Mass
    Posts
    281
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Nav/GPS indicator and Vacuum Indicator

    Quote Originally Posted by AK Mongo View Post
    You are saying Master Bus Voltage, but I assume you are actually using Main Bus Voltage, right? Main Bus Voltage is not a defined variable unless you added it.

    Reid
    Sorry, I meant to say "Main" not master. Based on Alan's direction I am going to do a file compare between the FS Variables files of the two pc's. almost everything else is similar.

  2. #12
    150+ Forum Groupie Tom_G_2010's Avatar
    Join Date
    Mar 2011
    Location
    Central Mass
    Posts
    281
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Nav/GPS indicator and Vacuum Indicator

    I have my NAV/GPS indicator working now. THANKS!!! I noticed below you mentioned yours was not working. When I get back home next week I'll e-mail you my file so you can see how mine is set up.

    I added the suction FS Variable and built that indicator as well, but I haven't had a chance to test it yet. I was looking an the annunciator panel in the stock FS 172 though and noticed that the vacuum indicator had two lamps: left; right. Need to do a little more digging on that one.

    As soon as I get the Main Bus Voltage issue debugged I'm also going to replace or maybe add it to each point where I have Battery Switch. If you leave the battery switch on long enough with out the engine started (or alternator switched on when it is) the battery will of course go dead. However my LED's still work since the present logic only triggers off the state of the battery switch not the presence of voltage. I will do the same with Avionics Voltage where the Avionics switch is.

    Again, Thanks for all your help!

  3. #13
    500+ This must be a daytime job



    Join Date
    Oct 2009
    Location
    Juneau, AK
    Posts
    547
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Nav/GPS indicator and Vacuum Indicator

    I did not set them up individually, because I could only find an offset for all suction, not left and right. I have no idea how to test in fs if it is subject to discrete failures, so I went with KISS.

    I agree about the volts(amps?) drop should cancel the lights as well, Just have not implemented it yet.

    You get your marker lights sorted out?

    Reid
    http://juneaucessnasim.blogspot.com
    N58243 (virtual)- Low and Slow...

  4. #14
    150+ Forum Groupie Tom_G_2010's Avatar
    Join Date
    Mar 2011
    Location
    Central Mass
    Posts
    281
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Nav/GPS indicator and Vacuum Indicator

    Quote Originally Posted by AK Mongo View Post
    . . . You get your marker lights sorted out? . . .
    Have them built but looking for a good airfield to test them at.

Page 2 of 2 FirstFirst 12