Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Super Moderator
    Join Date
    May 2006
    Location
    Texas
    Posts
    614
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Sneak preview, have a seat(rail)

    Those are simply awesome!

  2. #12
    500+ This must be a daytime job ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    604
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Sneak preview, have a seat(rail)

    Quote Originally Posted by Sean Nixon View Post
    So it's adios to the castors then!
    well i'm afraid so, but i have to say the castors did me proud just got to work out how i'm going to get in there and fit these.
    i've also got to 'block' them to raise the adaptor plates 2 inches because the existing carriers are 3 1/2 inches tall where these J rails
    are only 1 1/2 inches so as to protect the eyeline over the yoke/glareshield. never mind, keeps me out of the 'pub'
    have a great day chaps

    ian
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Which car seat could make a good platform for a 737NG seat ?
    By Nick1150 in forum Cockpit Parts and Motion Platforms
    Replies: 4
    Last Post: 07-29-2010, 05:17 PM
  2. Looking for long seat rail
    By airbus319 in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 12-21-2008, 07:48 PM
  3. 727 seat rail problem solved
    By Michael Carter in forum My Cockpit Update
    Replies: 9
    Last Post: 07-17-2008, 07:07 AM