A320 FMGS B44

[masterp]

P/B/D have worked for several years now...

Hi JL
Long time ago I tried to create PBD in "Next WPT" and it said not in database then I assume that it not worked
Last night I insert PBD directly in the F-PLN page and it work OK.
Thanks

[GoingForGold]

Somehow my joystick partially stopped working... In the configuration everything is fine and I can see the axis moving.
However in the sim not everything works.. all buttons are fine, even the slider used for the speed brakes work. But not the elevator, aileron and rudder axis. I doublechecked I have hydraulic pressure.

[Stephan Schwarz]

Maybe a double assignment of the axis somewhere in the sim or in FSUIPC?

[Leonidas]

Leonidas,
I will not correct anything because of third party addons.
It has been said that its best to load fuel from topcat when APU is not running, as the APU logic is the one foolling around the fuel consumption.
JL

JL
I've tried loading fuel without running APU and Ext Power too. So, exactly the same message, but never mind about it, I don't care.
Regards

[GoingForGold]

Maybe a double assignment of the axis somewhere in the sim or in FSUIPC?

Thanks for the idea..I completely deactivated the joystick in the sim, but I dont think I can completely delete the assignment. I dont use FSUIPC. And it worked until the update..

[Fritz]

Two small problems with the version B44 so far.
On one of my computers I could not run the Installer .
I received the error message, Microsoft .Net Framework 2.0 or higher have to be installed.
I have upgraded to Microsoft Windows 10. Net Framework is already installed.
Have also tried the Repair Tool of Net Framework. The problem remained.
I have installed the required modules on another computer (also Windows 10) then and copied from there.
So I have solved the problem .

In SIOC Creator I have insert the input 34 for the upper position and input 35 the lower position for the EMER EXIT LT.
When I press on Apply Configuration I get the error message

Phase 2
ERROR! - EMEREXITUP -
Line: 211 Var 102, name EMEREXITUP, Link IOCARD_SW, Device 0, Input 34
%FAILED%

I have checked whether the input 34 was already used elsewhere.
This was not the case. No idea why the assignment is not possible.

My first attempts with the new version have shown that the problem with the fuel and TeamViewer
no longer occurs. Thanks for the new version.

[Fritz]

My first attempts with the new version have shown that the problem with the fuel and TeamViewer
no longer occurs.

Too early happy! The problem with the fuel and TeamViewer persists.

I made a flight with Version B44 today. No other problems. Very stable.

One question. I had not been noticed that the switches of the ACPs could be assigned in the ITT Creator.
For the switch LEDs are no assignments possible in the ITT Creator. Is it planed to provid this in the next release?

[jeehell]

I forgot to add the LEDs in IIT creator, I'll try to put them in next release.

JL

[OmniAtlas]

One question. I had not been noticed that the switches of the ACPs could be assigned in the ITT Creator.
For the switch LEDs are no assignments possible in the ITT Creator. Is it planed to provid this in the next release?

It seems the Skalarki ACP is fully knob backlightable with ?functional volume control. Are these features already supported with the Skalarki DLL file and FMGS?

http://www.vier-im-pott.com/images/h...er_im_pott.jpg

Thank you.

[jeehell]

my software provides the SW/LEDs logic, but volume itself will not have much effect unless skalarki could interface that with the sound card or else...

JL